Been using this a few days now, would like to add thoughts for the v2.
1) maybe lower the wheels a bit so when the header is lowered the wheels touch the ground to stabilize the wide header.
2) maybe add sideblades for harvesting canola, (saw the video of it in irl, looked awesome.
3) maybe small orange or red sidemarkers on each side to detect the width of the header better in the dark.
when i used tit with the new hollad cr1090 the header bounced up-down weirdly when harvesting. im not sure if it's because i have ground response enabled or it's because the header itself.
3 Comments for MacDon FD75
Been using this a few days now, would like to add thoughts for the v2.
1) maybe lower the wheels a bit so when the header is lowered the wheels touch the ground to stabilize the wide header.
2) maybe add sideblades for harvesting canola, (saw the video of it in irl, looked awesome.
3) maybe small orange or red sidemarkers on each side to detect the width of the header better in the dark.
when i used tit with the new hollad cr1090 the header bounced up-down weirdly when harvesting. im not sure if it's because i have ground response enabled or it's because the header itself.
Thanks in advance :)
great cutter thanks! i would love to see the guide wheels setting the minimum cutting height but perhaps in V2.
good work ! i love you