Automated Drill by Ch3mast3r

The Automated Drill by Ch3mast3r

Has been made using the Xbox in Experimental mode. I have made an Automated Drill for processing stone or other materials. Could be put down over pockets of ore to get alot more than using a hand drill.

Built using large grid blocks using Timer blocks which have been programmed to hotkeys on Xbox

Hotkeys (Xbox)

1st Page

Up - Extend Out Pistons

Right - Increase Maximum value down piston (lower Pistons)

Down - Retract Out Pistons

Left - Decrease Maximum Down Value (Raise Pistons)

2nd Page

Up - Drills On/Off

Down - Toggle Reverse on Down Pistons

To get the drill to work properly go to the second page of the hotkeys

Press Up to switch the drills on,

then Down to reverse the down pistons.

Go to the first page then press Right until the drill makes contact with the ground. Once the drill has made contact with the ground.

On the first page press Up to extend the pistons out and to start the cut. Once the cut has been made press Right 3 times to extend the down pistons by roughly 3m. Then on the first page press Down to retract the pistons in and make the next cut.

Once the down pistons have reached thier maximum, cut off the drill heads and add more down pistons and put the drill heads back on and continue to use the Automated machine

I hope you enjoy using this Blueprint.

Ch3mast3r

I have set this drill up to dona cut out, then go down than come back in